Step 1
Bead Colors Needed:
Yellow - 149
Kiwi Lime - 41
Tan - 30

You will also need:
Large square pegboard
Iron and ironing paper
Key ring with a jump ring
Flat nose pliers
See the Supply List for beads and tools you can purchase.

Step 2
Download the PDF for the Pineapple Keychain Project Pattern. You will use the large square pegboard to create your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
ASSEMBLY: Use flat nose pliers to grasp and open the jump ring. Don't pull outward to separate the ends, instead, open the ring by twisting the ends in opposite directions.

Step 6
Slide the jump ring through the bead in the center top of the design, then close the ring by twisting the ends back together.