Step 1
Bead Colors Needed:
Hot Coral - 20
Neon Orange - 10
Rust - 33
Tan - 65
Light Brown - 6
Brown - 140
Grey - 70
See the Supply List for beads and tools you can purchase.

You will also need:
18 inches of clear lacing

Step 2
Download the PDF for the 3D Fireplace Project Pattern. You will use the small square pegboard for your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Now, place all the beads for the design.

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
ASSEMBLY: Align the pieces as shown and use the clear lacing to attach them.