Step 1
Download/print the PDF for the project patterns. If you are using a clear pegboard, slide the actual-size patterns underneath it. Place your beads, following the patterns.

Step 2
You will also need:
White cardstock, 12" x 12"
Craft glue
Double-sided tape

Step 3
Ask an adult to fuse your design. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard and bead design. In a circular motion, begin to iron the design. When ironed properly, the beads will still have open centers. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboard and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
Cut an 8" x 5 _" piece of the purple cardstock. Fold in half to create a 4" x 5 _" side-folding card.

Step 6
Cut out the artwork on page 2 of the pattern sheet. Use double-sided tape to attach to the card front.

Step 7
Position the Perler design on the card front. Secure with a small amount of craft glue. Note: If intending to mail the card, it may require additional postage due to thickness. ItŐs best to check with your local post office before mailing.