Step 1
Bead Colors Needed:
Magenta - 213
Hot Coral -172
Orange - 3
Cheddar - 64
Yellow - 41
Kiwi Lime - 228
White - 206
See the Supply List for beads and tools you can purchase.

You will also need:
Photo
Tape
Craft glue
Hook and loop tape

Step 2
Download the PDF for the Citrus Room Sign and Switchplate Cover Project Pattern. You will use the large square pegboard to create your projects. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
ASSEMBLY: Cut your photo to fit the opening on the cell phone. Tape it to the back so the picture shows through the opening. Glue the cell phone to the room sign as shown.

Step 6
Use hook and loop tape to secure your switchplate cover over the wall's switchplate.