Step 1
MINI BEAD COLORS NEEDED:
Light Blue - 15
Tan - 40
Grey - 39
Black - 123
White - 63

YOU WILL ALSO NEED:
Mini beads pegboard
Mini Beads tweezers
Iron and ironing paper
Necklace chain
Two 1/4" jump rings
Small needle-nose pliers
See the Supply List for beads and tools you can purchase here.

Step 2
CREATING THE DESIGN:
Download the PDF for the Mini Beads Camera Necklace Project Pattern. Slide the actual-size pattern underneath the pegboard and place your beads as shown.

Step 3
FUSING THE DESIGN: An adult should do this step.
Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. NOTE: Beads need heat for about 10 seconds per side to fuse evenly, it is possible some colors may need a little more time. Let the design cool.

Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. When the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Step 4
ASSEMBLY:
With the pliers, open the jump rings and slide through the open holes in the upper corners of the camera. Slide the chain onto the jump rings on each side, then close the rings with the pliers.