Step 1
Bead Colors Needed:
Peach - 35
Pink - 27
Red - 169
Cranapple - 57
Rust - 60
Cheddar - 50
Yellow - 139
Kiwi Lime - 41
Green - 225
Dark Green - 222
Toothpaste - 75
Light Blue - 56
Creme - 66
Sand - 89
Tan - 639
Light Brown - 224
Brown - 30
Grey - 21
White - 825
See the Supply List for beads and tools you can purchase.

You will also need:
Scissors
Clear tape

Step 2
Download the PDF for the Santa's Workshop Project Pattern. You will use 4 large square pegboards for your project. Some of the patterns require all 4 pegboards to be assembled together. Cut these patterns out and tape together in the same way as the pegboards are assembled. Place your beads on the pegboards as shown. If you are using clear pegboards, slide the actual-size pattern underneath them.

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
ASSEMBLY: Aligning slot to slot, insert the side sections 5 and 6 into the main part of the building.

Step 6
Your finished project should look like this.