Step 1
Bead Colors Needed:
Orange - 122
Glow-in-the-Dark Green - 830
Kiwi Lime - 139
Purple - 136
Clear - 28
Grey - 382
Black - 42
See the Supply List for beads and tools you can purchase.

You will also need:
Thread or fishing line
Two 16 inch lengths of 20 gauge wire
Pencil

Step 2
Download the PDF for the Scary Ghosties Project Pattern. You will use the large square pegboard for your projects. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
ASSEMBLY: Wrap each length of wire around a pencil to create a spring approximately 3-4 inches long.

Step 6
Ask an adult to help push the spring ends through the designs and feet as shown.

Step 7
Slide the feet onto the tombstone. Then slide the tombstone into the slot in the base.