Step 1
Download/print the PDF for the project pattern. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads, following the pattern.

Step 2
You will also need:
White wooden beads, 8mm
Clear filament

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard and bead design. In a circular motion, begin to iron the design. When ironed properly, the beads will still have open centers. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboard and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 5
Cut a length of filament to desired length.

Step 6
Thread wooden beads onto filament and secure both ends.

Step 7
Starting from the center and working out toward the ends, use a short length of the filament to tie each snowflake to the garland.