Wings

Wings

Let your spirit soar with these awesome butterfly wings made from Perler fuse beads! Use them as photo props at a special celebration or just for fun! Each wing features a variety of colorful motifs, including flowers, hearts, rainbows, trees, sun, moon, and stars. Constructed on large square interlocking pegboards, each wing measures approximately 29" x 40". After fusing the beads, mount each wing to a sturdy backing such as foam board or thick cardboard, then hang on a wall or other backdrop.

Instructions

Step 1
Download the PDF for the Wings Project Pattern. You will use the large square pegboard to create your projects. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.

Step 2
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. Let the design cool.

Step 3
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 4
After fusing the beads, mount each wing to a sturdy backing such as foam board or thick cardboard, then hang on a wall or other backdrop.