Step 1
Download/print the PDF for the project patterns. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads, following the patterns.

Step 2
You will also need (optional):
Snowflake buttons, 5/8" Đ 3 per hat
Craft glue

Step 3
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard and bead design. In a circular motion, begin to iron the design. When ironed properly, the beads will still have open centers. Let the design cool.

Step 4
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboard and ironing paper are reusable.

Step 5
Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step 6
Optional: Use a small dab of craft glue to attach 3 snowflake buttons to each hat.